Recent content by zeroz

  1. Z

    Reloading press confessions...Dumb ass move while at the press.

    Well, just stopped the bleeding and need a break because my finger is sore as shit. Was just doing a major 223 decapping session. Ripping through casings pretty fast, only lowering the ram enough to get the case out and a new one in. After God...
  2. Z

    Concentricity - too deep in the weeds?

    You are pretty deep in the weeds, fairway is over here.
  3. Z

    Reloading press confessions...Dumb ass move while at the press.

    I guess it feels better knowing Im not the only dipshit to smash my own finger. Swollen and sore as fuck this morning. I'm sure I have at least a nice little decap dent in the bone. It didn't quite cut my fingerprint to blood but you can still see the case mouth. Solid advice. I let it...
  4. Z

    Hodgdon Powder Shortage

    Its only BS if it wasn't you that bought.
  5. Z

    Reloading press confessions...Dumb ass move while at the press.

    Well, just stopped the bleeding and need a break because my finger is sore as shit. Was just doing a major 223 decapping session. Ripping through casings pretty fast, only lowering the ram enough to get the case out and a new one in. After God knows how many it was getting pretty...
  6. Z

    Tunnel shooting project

    Enough h-1000 will launch anything!
  7. Z

    Tunnel shooting project

    where is the pipe, how long are the sections and how much per section?
  8. Z

    10 round ladder test, Load close to lands?

    Uh, not great advice. If said good node is at the high end you could increase pressure to unsafe levels by moving toward the lands. Do the ladder test at the longest length you would want to run. If you want to single feed while hunting, do the ladder test at the lands. I assume you don't...
  9. Z

    Short 22 pistol for suppressor?

    I like the looks and features of that but like the glock, its a full size frame. I have that covered.
  10. Z

    Short 22 pistol for suppressor?

    I looked at one this morning. If it was on their smaller frame like a 42 I may have gone that route as they had a threaded barrel there for it. Its on the 17 frame so not quite as small as I am after.
  11. Z

    Short 22 pistol for suppressor?

    oooh. That little bobcat is cool, that is more along the lines of what I'm after. Just did a quick search and it looks like Beretta announced at SHOT that they will be releasing them with threaded barrels and "eventually" with suppressor height sights. Doesn't look like it happening until...
  12. Z

    Bigfatcock

    I had a hunt and then a family issue right before and during the VA rally and missed the demise of that original thread. Inquiring minds wanna know, you end up banging that snowflake chick in VA? Tell her after you were there to support 2A?
  13. Z

    QuietBore 22LR Titanium Suppressor Build Review -***Approved Form 1 Required***

    I think it said somewhere in this thread that 400-600 was best for Ti so it doesn't heat up and harden.
  14. Z

    QuietBore 22LR Titanium Suppressor Build Review -***Approved Form 1 Required***

    One reason would be if it is lost in the mail, somebody else gets it, drills it out and causes a ruckus. Assuming you filed a form 1 with said SN it could be tied to you and have implications