6.5 Creedmoor Rem700 Custom Build

Jan 10, 2011
474
2
18
40
Roundup, MT
#1
6.5 creedmoor Remington 700 SA build

This build was initially for my wife and then she wanted a 6.5PRC
It was test fired and then put away.

Work done
Receiver
Barrel. Cut to 22in and threaded 5/8-24 class 3A threads
Chambering
Threading with blended cap
Cerakote on barreled action
McMillan A5 cut for A5 Hawkins Bottom Metal.
Hawkins Bottom Metal
AICS 5 round magazine
Timney trigger
Barrel fluting
Bolt fluting
McMillian bipod picatiny rain mount and install
Glass bedding
Nightforce 20MOA scope rail
Side bolt release installed on receiver


$3265 worth of parts and work done. Make me an offer.
Plus shipping
But anyone serious just make me an offer on it.

Two things to mention about this rifle because the buyer needs to know this first. . The bolt had a machine glitch in the 4 axis when the bolt was fluted. So there is a small mark where the machine did not follow its rotational command. It’s barely noticeable.
I had this receiver back when I was in school and the tool broke when I cut the side bolt release and left a very small edge on one side of it that is slightly jagged but it’s on the inside of the bolt release. It’s not noticeable but I must tell you about it. I will send pics showing it. That being said this rifle was test fired for accuracy. It shot hornady factory ammo. 140 eld’s 5 shots just over a 1/4 inch at 100 yards.
In the pics I put my Suppressor and scope on it. Those are not part of the deal.

If you are serious or want to know anything. Message me and send me your phone number and I can call you and explain everything about it. It only has 20 rounds on it. I just shot a few groups and cleaned it and put it away.
 

Attachments