Results 1 to 6 of 6

Thread: bottom metal for tacticool savage mkII

  1. #1
    Full Member
    Follows
    0
    Following
    0

    Join Date
    Sep 2010
    Location
    Bulls Gap,TN
    Posts
    409

    bottom metal for tacticool savage mkII

    I have recieved a boyds stock. I need bottom metal. The plate around magazine,plus the trigger housing. where to find and know i am gettin the right thing. Cannot ge ahold of anyone at savage shooter, nor replys to email.

  2. #2
    Gunny Sergeant
    Follows
    0
    Following
    0
    Force_Multiplier's Avatar
    Join Date
    May 2008
    Location
    McAlester, Oklahoma
    Posts
    1,019

    Re: bottom metal for tacticool savage mkII

    stocky's gunstocks

  3. #3
    Online Training Member
    Follows
    0
    Following
    0

    Join Date
    Sep 2010
    Location
    Tenneseee, USA
    Posts
    468

    Re: bottom metal for tacticool savage mkII

    You can also call the Savage parts department. If you tell them what you are doing they will get you taken care of. Do remind them that you need the extra trigger guard screw.

    You may find that you want the thicker bottom metal for the mag well. I'm probably going to upgrade so I can properly torque the screws.

    Charlie

  4. #4
    Sergeant
    Follows
    0
    Following
    0

    Join Date
    Jan 2010
    Location
    Woodland Park, CO
    Posts
    992

    Re: bottom metal for tacticool savage mkII

    The Boyd's website now lists the part numbers you need to order from Savage. I just did this last week and it worked fine. Don't bother buying new action screws (I got talked into it), they're exactly the same as what you have. At least, they were for me.

    As for the thicker bottom plate, that's one solution. My plan is to bed the plate I have. Even without that, I was able to get sufficient torque.

    The rear screw on the trigger guard is a problem. Savage sent me a tiny little woodscrew for that, and it was way short. I had something lying around that I used, but you might be prepared for that.

  5. #5
    Sergeant
    Follows
    0
    Following
    0
    reeljob's Avatar
    Join Date
    Jan 2009
    Location
    Galax, VA
    Posts
    546

    Re: bottom metal for tacticool savage mkII

    I have four thick Bottom Metal pcs in my shop I finished bluing today. Shoot me a PM if you need one.
    Reeljob
    "Fear The Government That Fears Your Guns."--Thomas Jefferson
    II Corinthians X:IV

    My good guys
    Greene,sst04,Sealinck,HOP,Magforce,NeoShooter,Abil ene,MEAT4212,Stillbuster,Southbreeze,OGRESShooter, Rover31,Krummarine,Deadnoise,Phoneman,Stoney15,Tsa vo303,WDN-K-9,CEGA,Deadeye,Chefj,CharlieTN,Boydo,Ballistic,Cha rlieTN

  6. #6
    Rob Stringer
    Follows
    0
    Following
    0
    Strip Poker 388's Avatar
    Join Date
    Nov 2010
    Location
    Madison,Mississippi
    Posts
    194

    Re: bottom metal for tacticool savage mkII

    Boyds says they supply the tac stock to Savage for the TR.

    Did any of you notice that there is space /gap between the stock and the threaded part of the gun, like it needs a spacer as to not flex the wooden stock when tighting the baceplate screws?