Recent content by mark5pt56

  1. mark5pt56

    Bore sight question?

    On a bolt or AR, when you look through the bore, you see two rings, actually three, the chamber, beginning of the bore and the end of the bore, you simply "place" in ascending order the rings to have a good indicator of center. Although he couldn't do the above Watched a guy last week sling 60...
  2. mark5pt56

    Bore sight question?

    Yup, the mailbox down the street and looking through the bore method puts me with 3-4" on either a bolt or AR.
  3. mark5pt56

    Colt 1911 "Match" slide with Bomar rear

    This Colt slide is set for a match build. Now, I don't know what makes a "match" slide, this is not marked as such, just set up to be one. Slightly used, unk round count, I can take measurements the best I can with standard calipers within reason. The rear opening and along the slide length is...
  4. mark5pt56

    Ruger American Hunter, Magpul

    https://ruger.com/products/americanRifleHunter/specSheets/26993.html?buy=1 Looking at a basic .308 rifle. Tikka CTR SS .308 Ruger American Hunter/Magpul .308 Intent on the Tikka would be to add a Tikka Performance AICS bottom metal to have the AICS mag capability. Other than that, stock for...
  5. mark5pt56

    Any .223 CA MPR reviews?

    Looking at an "off the shelf" .223 bolt, short, weight not really an issue. Hoping a member has one of these
  6. mark5pt56

    Any .223 CA MPR reviews?

    Anyone own one of the .223 variants of the MPR and have feedback? Debating the ss barrel or CF and accuracy. Mark
  7. mark5pt56

    Accuracy International AT - Worth It?

    I started with a Rem 700p in an AI chassis, saved/sold and went AEII, same, AEIII and now an AT. I think some AR's might go by by towards election time and do an AX. Keeping the AT though. Fiddle f'ed with a couple custom rigs and factory rigs throughout the years, some cool and nice rigs but...
  8. mark5pt56

    Accuracy International AT - Worth It?

    OP, get the AI, you won't regret it. While some "custom" guns may look cool, etc. I for one could give two shits if Moses himself built it. Most people don't like to pay for labor and that's what some folks try to sell when their ugly child gets old. Have the AT with 6.5cm barrel. I should...
  9. mark5pt56

    sold_______________Federal Trophy Copper-.308--trades

    I picked this up about 3 years ago, squirreled it away for a lifetime of hunting. Been in those cans and inside the whole time. 150 grain Don't "need" to sell it, so if you want Walmart prices-go there and buy the Fudd stuff. Online appears to be 1.50 per round. MAKE SURE YOU CAN RECEIVE FROM...